<aside> 🚨

This Tutorial describes just the basic steps of Lasercutting & -engraving. For more details consult the staff or the internet.

Note that using the Laser Equipment requires a seperate introduction by staff.

</aside>

Laser Setup

1. Laser
2. On/Off Switch
3. Fume Extractor
4. Fire Extinguisher
   1. On/Off Switch
   2. Extinguisher (use in case of fire inside the laser)
5. Fume Extraction Controls
6. Material Samples (with parameters)
7. iMac & X-Tool Software
8. Emergency Stop

Preparing your Files

For Cutting & Line Engraving

• prepare your data as a vectorised file (using e.g. Adobe Illustrator)
• export your vectorised data as an .svg file
• you can choose which paths to cut and which to engrave later, using the X-Tool Software